Rancangan Welding Fixture Pembuatan Produk Front Engine Mounting Mobil Suzuki Baleno

Authors

  • Hendro Prassetiyo Fakultas Teknologi Industri, Jurusan Teknik Industri, Institut Teknologi Nasional Jl. P.H.H. Mustafa No. 23, Bandung 40124
  • ~ Rispianda Fakultas Teknologi Industri, Jurusan Teknik Industri, Institut Teknologi Nasional Jl. P.H.H. Mustafa No. 23, Bandung 40124
  • Puspita Dewi Fakultas Teknologi Industri, Jurusan Teknik Industri, Institut Teknologi Nasional Jl. P.H.H. Mustafa No. 23, Bandung 40124

DOI:

https://doi.org/10.26593/jrsi.v4i2.1631.97-105

Abstract

Manufacture industry develops very rapidly, it could be seen from the various technology that is used in
the process of the production. This developments causes the increasing of consumers needs, so the businessmen
of manufacture have to be able to increase the quality and quantity of the products that are produced. One
of the way to increase it that is by using aids of productions which are Jig and Fixture. This paper is talking
about the design of Welding Fixture which this kind of fixture is always used for welding processes. These
aids are used for the welding process of front engine mounting cars products of Suzuki Baleno. The design of
welding fixture is done to decrease the defects of the products caused by the less precise components placement
when the welding process is underway. Moreover, the design is done to hasten the processes of loading and
unloading (setup).

Downloads

Published

2015-11-25